SC-80 Inktense Wood Scale75 ink paint card (#5C3A18)

SC-80 Inktense Wood is a ink from Scale75, commonly used for armour plates, cloth, and trim work.

Quick Equivalents

• Closest equivalent: Oil Paint Raw Umber (AK Interactive) – ΔE 4.9
• Vallejo equivalent: no close Vallejo equivalent
• Army Painter equivalent: Voodoo Shade (Army Painter) – ΔE 5.5

How to Use SC-80 Inktense Wood

This paint is typically used for:

• basecoating warm orange armour and weapons
• layering and highlighting on large flat surfaces

Apply it over a suitable primer and build layers gradually. Coverage sits around reliable, so two thin coats usually give a more stable finish than one heavy pass, especially over a dark primer.

Paint Behavior and Tips

Consider the following when working with this paint:

• Coverage: reliable — affects how many coats are needed over primer
• Dilution: controlled thinning — keeping the right ratio maintains flow and prevents brushmarks
• Interaction with washes and highlights: always run a highlight pass to verify the tone does not shift after drying

A good equivalent should remain stable after shading and highlighting. Test this alternative on the same primer and in the same recipe before switching a whole unit.

Miniature Painting Tips

For best results with SC-80 Inktense Wood on Warhammer and other miniature projects:

• Use the same primer across the project to keep tonal consistency
• Test on a spare part before applying to a full unit
• Compare after shading and highlights, not just the base coat

Even small differences can become visible on a finished miniature. This match may behave differently on textured surfaces like cloth, fur, and metal trim once the full recipe is applied.

Conclusion

Choosing the right SC-80 Inktense Wood equivalent or substitute keeps your scheme consistent from the test model to the full army. Use this comparison to weigh the closest Vallejo, Army Painter, and other cross-brand options before repainting a whole squad.